Like we said before, the limiter/compressor is very important because it prevents signal splatter and distortion. To properly set up the mixer, limiter/comperssor and transmitter, start with a steady audio source (a test tone CD or signal generator plugged into the mixer). Then you adjust the input level and master output level controls so that the meters are reading zero dB. Master level controls should be at mid position. Audio output goes from the mixer to the limiter/compressor and from there to the transmitter. Do not turn the transmitter on yet.

19

Indicators show gain reduction is being applied and the output level

Set the ratio control to the infinity setting. This engages the hard limit function

Set the attack and decay at mid position